Net AN035 Integating Net with an intude alam system Oveview Net can monito whethe the intude alam is set o uet If the alam is set, Net will limit access to valid uses who ae also authoised to uet the alam All othe uses will be denied access, egadless of thei nomal access level Uses can be pevented fom gaining access though othe selected doos (eg back doo) by also connecting these ACU's to an alam status pai While allowing the fist access by an authoised use, Net will send a signal to uet the alam automatically If this is successful the doo is unlocked and the system esumes nomal opeation using standad access levels fo all uses Configuing Net to allow alam integation To configue alam patitio see: AN3 - Integating with Multi Zone Intude / Texecom patitio < http://paxtoninfo/790 > Net softwae befoe v4 equies the Net alam integation softwae check box to be ticked in the Featues tab of the Net eve Configuation Utility Uetting the alam When an authoised use pesents thei token to the IN eade: The eade will flash the Ambe and Red LED's to indicate that the alam is The ACU will ty to Uet the alam via its contacts When the alam is confimed as Uet, the LED will flash and the doo will unlock The eade will now wok as nomal fo all uses until the alam is again Unauthoised uses ae efused enty while the alam emai set
ting the Alam Net AN035 When an authoised use pesents thei token to the IN o OUT eade and povides button confimation : The ACU will ty to the alam via its contacts When the alam is confimed as, the eade will illuminate the Red LED fo 30 seconds The eade will display the Red, Ambe and LED's Configuing a doo to contol the intude alam To enable alam integation at a specific doo, select the ACU, go to the intude alam tab and check the tick box You must then define the following optio: Define if the set/uet indication fom the intude alam is an open o closed pai pecify the time peiod fo which the Net elay contacts need to close to change the intude alam state (0 to 0 seconds) pecify if the doo should unlock on the thid attempt even if the alam is still set the time peiod fo the confimation button - if fitted (up to 0 secs) pecify an altenative eade opeating mode while the alam is set - if equied ACU Connectio - and Net classic The diagams in this document ae dawn with efeence to the ACU The wiing on the uses a dedicated Intude alam pot Inputs ae povided to ee the cuent alam condition ( /Un) and an confimation button The intude elay povides voltage fee outputs (NO/ NC) to the alam when equied Ealy vesio of the ACU do not have an NC teminal on the elay Contact Technical suppot fo advice if equied The Net classic has the inputs wied to the Keypad teminals The output is taken fom A wiing efeence table is included with each application
Use ecods Net AN035 OThe following tick box appeas in each use ecod This must be ticked to give the use the authoity to set/ uet the alam B843:00 Compliance Fo compliance with B843:00 (fomally DD43: 004) if integating an access contol system with an intude alam it is ecommended that a dedicated ACU is used to set the alam in addition to the guidelines outlined within section 6 of the Bitish tandads document Uetting the alam The ACU that is used fo nomal building access also uets the alam It equies a 'status' input fom the alam and also a 'key switch' (uet) connection to the alam A valid token fom an authoised use at the IN eade ( ) will uet the alam and then unlock the doo in the nomal way This ACU can use Read In and Out fo nomal access contol if equied ( & ) To intude alam momentay key switch input C aution: Fo V DC eades onl y 0 eve Link 00 0/00 Ethenet coes ceen o spae fom data Wht/Gn Wht/Ong Oange U/Tampe ontac t P xit Butto C n R elay E -4V contol unit (optional) A Net classic can be used in this application The equivalent wiing connectio ae shown as follows: Wie Net classic ee o NC Keypad o NC 3
ting the Alam Net AN035 A second ACU is dedicated to setting the alam and has no lock connected to it Connectio ae made, as with the fist ACU to the alam status and to the 'key switch' (set) input on the alam panel These may be wied in paallel with fist ACU but you must eue the same polaity is used fo both The system needs a final confimation signal to show that the use is outside the building befoe the alam is set This is nomally povided by an extenal button Pesenting a keyfob will activate the system ceating the equest The ACU will check the keyfob agait its authoised use list If it is, the ACU waits fo the push button confimation signal and then sets the alam Extenal confimation button To intude alam momentay key switch input C aution: Fo V DC eades onl y 0 eve Link 00 0/00 Ethenet ceen o spae coes fom data Wht/Gn Wht/Ong Oange U/Tampe ontac t P xit Butto C n R elay E -4V contol unit A Net classic can be used in this application The equivalent wiing connectio ae shown as follows: Wie Net classic Keypad Bown ee Keypad o NC o NC 4
tandad access contol (one ACU) with an am confimation button Net AN035 The Net opeates fo all staff as nomal while the alam is uet You can use two eades with this ACU fo In/Out opeation UNET - A valid token fom an authoised use at the IN eade ( ) will uet the alam and then unlock the doo in the nomal way ET - When an authoised use wants to set the alam as they leave the building, they pesent thei token to eithe eade as nomal, unlocking the doo If they also pess the confimation button within the specified time peiod, the intude alam will set itself and the LED's will flash in confimation fo 30 seconds befoe etuning to thei nomal display Extenal confimation button To intude alam momentay key switch input C aution: Fo V DC eades onl y 0 eve Link 00 0/00 Ethenet ceen o spae coes fom data Wht/Gn Wht/Ong Oange U/Tampe ontac t P xit Butto C n R elay E -4V contol unit (optional) A Net classic can be used in this application The equivalent wiing connectio ae shown as follows: Wie Net classic Keypad Bown ee o NC Keypad o NC 5
tandad access contol (one ACU) with keypad(s) Net AN035 The * key on a Paxton keypad can be used itead of fitting a confimation push button The Net opeates fo all staff as nomal while the alam is uet You can use two eade/keypads with this ACU fo In/Out opeation UNET - A valid PIN fom an authoised use at the IN keypad ( ) will uet the alam and then unlock the doo in the nomal way ET - When an authoised use wants to set the alam as they leave the building, they fist pess the * key ( o ) and will then be given 7 seconds to ente thei PIN This unlocks the doo as nomal and then elocks the doo and sets the alam system The LED's will flash in confimation fo 30 seconds befoe etuning to thei nomal display If using Token + PIN, the use must still stat the sequence with the * key befoe pesenting thei token and enteing thei PIN numbe To intude alam momentay key switch input Keypad C aution: Fo V DC eades onl y 0 eve Link 00 0/00 Ethenet ceen o spae coes fom data Wht/Gn Wht/Ong Oange U/Tampe ontac t P xit Butto C n R elay E -4V contol unit Keypad (optional) A Net classic can be used in this application The equivalent wiing connectio ae shown as follows: Wie Net classic ee o NC Keypad o NC 6
Blocking othe doos while the alam is set Net AN035 Uses can be pevented fom gaining access though othe selected doos (eg back doo) by also connecting these ACU's to an alam status pai Alam integation must be enabled on the ACU A set/uet connection to the alam panel is not necessay as this ACU does not change the status of the alam system If moe than ACU is wied to the same alam, make sue that the polaity of these wies is the same on all ACU's o the system will not wok coectly C aution: Fo V DC eades onl y 0 eve Link 00 0/00 Ethenet coes ceen o spae fom data Wht/Gn Wht/Ong Oange P U/Tampe ontac t xit Butto C n R elay E -4V contol unit (optional) A Net classic can be used in this application The equivalent wiing connectio ae shown as follows: Wie Net classic ee Keypad 7
Manual alam set/uet - Blocking unauthoised access Net AN035 This is used whee the alam panel is iide the building and the owne still wants to use the panel to manually set/ uet the alam This will not be DD43 compliant as a use is allowed into the building while the alam is still set To allow an authoised use access to the building, we need to tempoaily tell the ACU that the alam status is 'uet' This allows thei token to unlock the oute doo This is done by ceating an 'uet' status signal by mea of the elay which will mimic the 'uet' signal This gives the use access to the building to uet the alam manually which then povides the 'tue' uet signal fo the ACU Net will show multiple set/uet events if the ACU elay etu befoe the alam has been manually uet at the panel The wiing of the elay will depend on the type of status uet signal povided by the panel ( open o closed cicuit ) The ACU elay must simulate the signal by making o beaking this status pai Use when closed pai indicates uet C aution: Fo V DC eades onl y 0 eve Link 00 0/00 Ethenet ceen o spae coes fom data Wht/Gn Wht/Ong Oange P U/Tampe C ontac t E xit Butto n R elay -4V contol unit (optional) 8
Net AN035 Use when open pai indicates uet C aution: Fo V DC eades onl y 0 eve Link 00 0/00 Ethenet ceen o spae coes fom data Wht/Gn Wht/Ong Oange P U/Tampe ontac t xit Butto C n R elay E -4V contol unit (optional) A Net classic can be used in this application The equivalent wiing connectio ae shown as follows: Wie Net classic ee o NC Keypad o NC Impotant Notes - All ystems If the doo on the ACU is nomaly held open with a timezone, the ACU will not unlock the doo until the intude alam has been uet The eade opeating mode can be changed depending on the alam condition (eg Token + PIN when set and Token Only when uet) by setting the function on the sceen The Net classic elay is not available fo doo contol and so the toggle option unde action is geyed out Any ACU that is used fo alam integation and access contol must have the lock wies connected to elay 9